LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication System (A25A-FKS) - Service Information >> ENGINE OIL COOLER (w/ Oil Cooler) >> Installation [11/2018 - ] >> Procedure

Installation [11/2018 - ]: Procedure

  1. INSTALL OIL COOLER ASSEMBLY 
    1. Install a new oil control valve filter to the cylinder block sub-assembly.
    2. Install 2 new oil cooler gaskets to the oil cooler assembly.
    3. Install the oil cooler assembly to the cylinder block sub-assembly with the 4 bolts.

      Torque: 16 N.m (163 kgf/cm, 12 ft.lbf) 

    4. Connect the No. 1 water by-pass hose and No. 2 water by-pass hose to the oil cooler assembly, and slide the 2 clips to secure them.
  2. ADD ENGINE OIL 

    Refer to PROCEDURE - Step 5 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 5 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 5 [12/2021 - 10/2023] , or refer to PROCEDURE - Step 5 [10/2023 - ]

  3. ADD ENGINE COOLANT 

    Refer to PROCEDURE - Step 2

  4. INSPECT FOR COOLANT LEAK 

    Refer to PROCEDURE - Step 1

  5. CHECK ENGINE OIL LEVEL 

    Refer to PROCEDURE - Step 1 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 1 [08/2020 - 10/2023] , or refer to PROCEDURE - Step 1 [10/2023 - ]

  6. INSPECT ENGINE OIL LEAK 

    Refer to PROCEDURE - Step 6 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 6 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 6 [12/2021 - 10/2023] , or refer to PROCEDURE - Step 6 [10/2023 - ]

  7. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY 

    Refer to PROCEDURE - Step 99 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 99 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 99 [12/2021 - ]

  8. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 100 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 100 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 100 [12/2021 - ]

  9. INSTALL FRONT FENDER FRONT SPLASH SHIELD RH 

    Refer to PROCEDURE - Step 102 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 102 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 102 [12/2021 - ]

  10. INSTALL FRONT FENDER FRONT SPLASH SHIELD LH 

    Refer to PROCEDURE - Step 101 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 101 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 101 [12/2021 - ]

scientia non olet · About LEMON Manuals