LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) - Service Information (4 Of 4) >> Fuel Lid Opener Motor Assembly >> Removal [02/2019 - 08/2020] >> Procedure

Removal [02/2019 - 08/2020]: Procedure

  1. REMOVE REAR SEAT ASSEMBLY 

    Refer to REMOVAL [11/2018 - ]

  2. REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 6

  3. REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover) 

    Refer to PROCEDURE - Step 1

  4. REMOVE DECK BOARD ASSEMBLY 

    Refer to PROCEDURE - Step 2

  5. REMOVE REAR NO. 3 FLOOR BOARD 

    Refer to PROCEDURE - Step 4

  6. REMOVE REAR FLOOR FINISH PLATE 

    Refer to PROCEDURE - Step 10

  7. REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE 

    Refer to PROCEDURE - Step 21

  8. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH 

    HINT: 

    Remove the rear door opening trim weatherstrip LH so that the center pillar lower garnish LH and rear seat No. 3 side garnish LH can be removed.

    Refer to PROCEDURE - Step 2

  9. REMOVE REAR SEAT SIDE GARNISH LH 

    Refer to PROCEDURE - Step 39

  10. REMOVE TETHER ANCHOR BRACKET SET 

    Refer to PROCEDURE - Step 41

  11. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY 

    Refer to PROCEDURE - Step 42

  12. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH 

    Refer to PROCEDURE - Step 43

  13. REMOVE FUEL FILLER OPENING LID LOCK COVER (w/ Canister Pump Module) 
    1. Detach the claw and remove the fuel filler opening lid lock cover as shown in the illustration.
      GTY922538Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction

      HINT: 

      The fuel filler opening lid lock cover is a non-reusable part. Make sure to replace it with a new one.

  14. REMOVE FUEL FILLER OPENING LID LOCK RETAINER 
    1. Rotate the fuel filler opening lid lock retainer clockwise and detach the guide, then remove the fuel filler opening lid lock retainer as shown in the illustration.
      GTY854922Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction

      HINT: 

      The fuel filler opening lid lock retainer is a non-reusable part. Make sure to replace it with a new one.

  15. REMOVE FUEL LID LOCK WITH MOTOR ASSEMBLY 
    1. Detach the guide and remove the fuel lid lock with motor assembly as shown in the illustration.
      GTY932733Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    2. Disconnect the connector.
scientia non olet · About LEMON Manuals