Adjustment [11/2018 - ]: Procedure

INSPECT REAR DOOR PANEL SUB-ASSEMBLY LH

Check that the clearance measurements of areas A to K are within the standard ranges.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

STANDARD CLEARANCE

Area	Measurement	Area	Measurement
A (Reference)	5.1 mm (0.201 in.)	B (Reference)	0 mm (0 in.)
C	2.9 to 5.3 mm (0.114 to 0.209 in.)	D	-1.5 to 0.9 mm (-0.0591 to 0.0354 in.)
E	2.9 to 5.3 mm (0.114 to 0.209 in.)	F	-1.5 to 0.9 mm (-0.0591 to 0.0354 in.)
G	2.65 to 6.05 mm (0.104 to 0.238 in.)	H	3.15 to 7.15 mm (0.124 to 0.281 in.)
I	3.3 to 7.3 mm (0.130 to 0.287 in.)	J	2.2 to 5.2 mm (0.0866 to 0.2047 in.)
K	-1.8 to 1.2 mm (-0.0709 to 0.0472 in.)	-	-

ADJUST REAR DOOR PANEL SUB-ASSEMBLY LH

Loosen the hinge bolts on the body and adjust the door position.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Tighten the hinge bolts on the body after the adjustment.
Torque: 26 N.m (265 kgf/cm, 19 ft.lbf)

Loosen the hinge bolts on the door and adjust the door position.

Tighten the hinge bolts on the door after the adjustment.
Torque: 21 N.m (214 kgf/cm, 15 ft.lbf)

Using a T40 "TORX" socket wrench, adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a brass bar and a hammer.

Using a T40 "TORX" socket wrench, tighten the striker mounting screws after the adjustment.
Torque: 23 N.m (235 kgf/cm, 17 ft.lbf)