Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the power back door unit assembly removal/installation are shown below.
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR HV MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Reset connection history | There are cases where the connection history display differs from the vehicle condition | Refer to DATA LIST / ACTIVE TEST [11/2018 - 10/2023] |
| Reset back door close position | Power back door system (for HV model) | Refer to INITIALIZATION [11/2018 - 10/2023] |
NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED (FOR GASOLINE MODEL)
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Reset connection history | There are cases where the connection history display differs from the vehicle condition | Refer to DATA LIST / ACTIVE TEST [11/2018 - 10/2023] |
| Reset back door close position | Power back door system (for Gasoline model) | Refer to INITIALIZATION [11/2018 - 10/2023] |
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure below is for the LH side.