LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) - Service Information (3 Of 4) >> Back Door Opener Switch >> Inspection [11/2018 - ] >> Procedure

Inspection [11/2018 - ]: Procedure

  1. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY (w/ Smart Key System) 
    1. Check the operation of the back door opener switch assembly.
      GTY938472Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Not Pushed (OFF)
      *b Pushed (ON)
      *c Component without harness connected
      (Back Door Opener Switch Assembly)
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Switch Condition Specified Condition
        3 (UL) - 2 (E) Back door opener switch pushed (ON) Below 1 Ω
        3 (UL) - 2 (E) Back door opener switch not pushed (OFF) 10 kΩ or higher

        If the result is not as specified, replace the back door opener switch assembly.

    2. Check the operation of the back door lock switch.
      GTY915757Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Not Pushed (OFF)
      *b Pushed (ON)
      *c Component without harness connected
      (Back Door Opener Switch Assembly)
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Switch Condition Specified Condition
        1 (L) - 2 (E) Back door opener switch pushed (ON) Below 1 Ω
        1 (L) - 2 (E) Back door opener switch not pushed (OFF) 10 kΩ or higher

        If the result is not as specified, replace the back door opener switch assembly.

  2. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY (w/o Smart Key System) 
    1. Check the operation of the back door opener switch assembly.
      GTY848178Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Not Pushed (OFF)
      *b Pushed (ON)
      *c Component without harness connected
      (Back Door Opener Switch Assembly)
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Switch Condition Specified Condition
        3 (UL) - 2 (E) Back door opener switch pushed (ON) Below 1 Ω
        3 (UL) - 2 (E) Back door opener switch not pushed (OFF) 10 kΩ or higher

        If the result is not as specified, replace the back door opener switch assembly.

scientia non olet · About LEMON Manuals