LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 XLE, AWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) - Service Information (3 Of 4) >> Back Door Closer Ecu >> Removal [11/2018 - 10/2023] >> Procedure

Removal [11/2018 - 10/2023]: Procedure

  1. REMOVE BACK DOOR CENTER GARNISH 

    See step  1

  2. REMOVE BACK DOOR SIDE GARNISH LH 

    See step  2

  3. REMOVE BACK DOOR SIDE GARNISH RH 

    HINT: 

    Use the same procedure described for the LH side.

  4. REMOVE BACK DOOR GRIP BASE 

    See step  4

  5. REMOVE BACK DOOR GRIP 

    HINT: 

    Use the same procedure described for the back door grip base.

  6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY 

    See step  6

  7. REMOVE MULTIPLEX NETWORK DOOR ECU 
    1. Remove the 2 bolts.
      GTY929956Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Bolt
      Connector
    2. Detach the guide and remove the multiplex network door ECU.
    3. Disconnect the 2 connectors.
      NOTE:
      • Do not subject the multiplex network door ECU to strong impacts or force, and do not drop it.
      • Do not reuse the multiplex network door ECU that has been dropped.
scientia non olet · About LEMON Manuals