Installation [02/2019 - 12/2021]: Procedure

1. Install the rear upper coil spring insulator to the vehicle.

1. Install the rear lower coil spring insulator to the rear No. 2 suspension arm assembly.

1. for TMC Made:
   1. Set the rear coil spring to the rear No. 2 suspension arm assembly.
      NOTE:

      • Set the rear coil spring so that its lower end is within the range shown in the illustration.
      • Set the rear coil spring so that the identification mark is positioned as shown in the illustration.
      • The smaller diameter end must face upward.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *a	Identification Mark
      *b	30° or less
      *c	Lower End of Rear Coil Spring
      	Inner Side of the Vehicle

2. for TMMC Made:
   1. Set the rear coil spring to the rear No. 2 suspension arm assembly.
      NOTE:

      • Set the rear coil spring so that its lower end is within the range shown in the illustration.
      • Set the rear coil spring so that the identification mark is positioned as shown in the illustration.
      • The smaller diameter end must face upward.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *a	Identification Mark
      *b	30° or less
      *c	Lower End of Rear Coil Spring
      	Inner Side of the Vehicle

3. Using a jack and wooden block, slowly jack up the rear No. 2 suspension arm assembly and then install the rear No. 2 suspension arm assembly to the rear axle carrier sub-assembly with the bolt and nut.
   WARNING:

   Do not jack up the rear No. 2 suspension arm assembly too high as the vehicle may fall.

   NOTE:

   • Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
   • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.
   • Make sure to perform this operation with the vehicle kept as low as possible.
   • Insert the bolt with the threaded end facing the front of the vehicle.

See step  4

1. Install the rear No. 2 suspension arm assembly (rear axle carrier sub-assembly side) with the bolt.

   Torque: 73 N.m (744 kgf/cm, 54 ft.lbf) 

   NOTE:

   Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

See step  7

See step  9

1. for LH Side:

   Refer to INSTALLATION [02/2019 - 12/2021]

Refer to INSTALLATION [11/2018 - ]

1. Install the rear No. 2 suspension arm assembly (rear suspension member sub-assembly side) with the nut.

   See step  12

Refer to ADJUSTMENT [11/2018 - 08/2020] , or refer to ADJUSTMENT [08/2020 - 12/2021]

Refer to INITIALIZATION [02/2019 - 10/2019] , or refer to INITIALIZATION [10/2019 - 06/2020] , or refer to INITIALIZATION [06/2020 - 08/2020] , or refer to INITIALIZATION [08/2020 - 12/2021]