Removal [02/2019 - 10/2019]: Procedure

PRECAUTION

WARNING:

Be sure to read Precaution thoroughly before servicing.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

w/ Occupant Classification System:
Refer to PRECAUTION [02/2019 - 08/2020]
w/o Occupant Classification System:
Refer to PRECAUTION [11/2018 - 08/2020]

NOTE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Refer to PRECAUTION [11/2018 - ]

REMOVE DECK BOARD ASSEMBLY (for HV Model)
Refer to PROCEDURE - Step 2
REMOVE NO. 2 REAR FLOOR BOARD (for HV Model)
Refer to PROCEDURE - Step 3
REMOVE BATTERY HOLE COVER (for HV Model)
Refer to PROCEDURE - Step 4

DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

for A25A-FXS:
Refer to PROCEDURE - Step 5

for A25A-FKS:

Refer to PROCEDURE - Step 2

WARNING:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.

NOTE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [02/2019 - 10/2019]

REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH
Refer to PROCEDURE - Step 6
REMOVE FRONT DOOR ASSIST GRIP COVER LH
Refer to PROCEDURE - Step 7
REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
Refer to PROCEDURE - Step 8
REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
Refer to PROCEDURE - Step 11
REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 14
REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH
Refer to PROCEDURE - Step 17
REMOVE FRONT DOOR FRONT BELT SEAL LH
Refer to PROCEDURE - Step 19
REMOVE FRONT DOOR SERVICE HOLE COVER LH
Refer to PROCEDURE - Step 23
REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 25
REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 28

REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

Using a T25 "TORX" socket wrench, remove the 3 "TORX" screws and power window regulator motor assembly LH from the front door window regulator sub-assembly LH.