LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 LE, AWD >> Repair and Diagnosis >> Suspension >> Front Suspension >> Suspension System (Front) - Service Information (2 Of 2) >> FRONT SUSPENSION MEMBER (for Gasoline Model) >> Removal [02/2019 - 10/2019] >> Procedure

Removal [02/2019 - 10/2019]: Procedure

  1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE 

    Refer to REMOVAL [11/2018 - 10/2019]

  2. REMOVE FUEL DELIVERY GUARD 

    Refer to PROCEDURE - Step 62

  3. INSTALL ENGINE HANGERS 

    Refer to PROCEDURE - Step 63

  4. REMOVE STEERING GEAR HEAT INSULATOR 

    Refer to PROCEDURE - Step 9

  5. DISCONNECT WIRE HARNESS 

    Refer to PROCEDURE - Step 10

  6. REMOVE FRONT FRAME ASSEMBLY (for 2WD) 
    1. Remove the 3 nuts and separate the front engine mounting insulator from the front frame assembly.
      GTY874984Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 4 nuts and separate the rear engine mounting insulator from the front frame assembly.
      GTY934268Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE FRONT FRAME ASSEMBLY (for AWD) 
    1. Remove the 3 nuts and separate the front engine mounting insulator from the front frame assembly.
      GTY874984Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 4 nuts and separate the rear engine mounting insulator from the front frame assembly.
      GTY874983Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE FRONT STABILIZER BAR WITH BRACKET 

    Refer to PROCEDURE - Step 14

  9. REMOVE RACK AND PINION POWER STEERING GEAR ASSEMBLY 

    Refer to PROCEDURE - Step 15

  10. REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH 
    1. Remove the 3 bolts, nut and front lower No. 1 suspension arm sub-assembly LH from the front frame assembly.
      NOTE:

      Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.

      GTY930912Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the front lower arm bushing stopper from the front lower No. 1 suspension arm sub-assembly.
  11. REMOVE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY RH 

    HINT: 

    Perform the same procedure as for the LH side.

  12. REMOVE NO. 2 EXHAUST PIPE SUPPORT BRACKET 
    1. Remove the 2 bolts and No. 2 exhaust pipe support bracket from the front frame assembly.
      GTY859639Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals