LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 LE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Engine Mechanical System (A25A-FXS) - Service Information (1 Of 6)) >> Camshaft >> Removal [02/2019 - 10/2019] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during camshaft removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
  • Replacement of fuel pump assembly (for high pressure side)
  • Replacement of ignition coil assembly
  • Replacement of throttle body with motor assembly
  • Cleaning the deposits from the throttle body with motor assembly
  • Gas leak from exhaust system is repaired
  • Replacement of cam timing control motor with EDU assembly
  • Replacement of camshaft timing gear assembly
  • Replacement of camshaft (for intake or exhaust camshaft)
  • Replacement of camshaft timing exhaust gear assembly
  • Removal and installation of a cam timing control motor with EDU assembly
  • Removal and installation of a camshaft timing gear assembly
 Inspection after repair
  • Poor idle, etc.
  • Engine start function, etc.
 Refer to INITIALIZATION [02/2019 - 10/2019] (w/ Canister Pump Module)
Refer to INITIALIZATION [11/2018 - 08/2020] (w/o Canister Pump Module)
NOTE:
  • After the power switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the power switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) auxiliary battery terminal.
    WAITING TIME BEFORE DISCONNECTING CABLE FROM NEGATIVE (-) AUXILIARY BATTERY TERMINAL

    System Name See Procedure
    Vehicle enrolled in Toyota Entune system or safety connect system 6 minutes
    Vehicle not enrolled in Toyota Entune system and safety connect system 1 minute
  • This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

    Refer to PRECAUTION [11/2018 - ]

scientia non olet · About LEMON Manuals