LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 LE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Hybrid Transaxle System (P710) - Service Information (2 Of 2)) >> Hybrid Transaxle Oil Seal >> Replacement [08/2020 - 12/2021] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front drive shaft oil seal LH or front drive shaft oil seal RH removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front wheel alignment adjustment
  1. Clear zero point calibration data and stored linear solenoid valve calibration data
  2. Initialization and calibration of the linear solenoid valve
  3. Yaw rate and acceleration sensor zero point calibration
 VSC malfunction Refer to UTILITY [02/2019 - 12/2021]
scientia non olet · About LEMON Manuals