LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 LE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 150 (Hybrid Transaxle System / Rear Traction Motor (Q610) - Service Information) >> Hybrid Transaxle Side Gear Oil Seal >> Replacement [10/2022 - ] >> Caution / Notice / Hint

Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear drive shaft oil seal LH or rear drive shaft oil seal RH removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear wheel alignment adjustment
  1. Perform "Reset Memory"
  2. Perform "Calibration"
  • DTCs are stored
  • ABS warning light illuminates
  • Brake system warning light (yellow indicator) illuminates
  • Slip indicator light illuminates
  • Brake control disabled or malfunctions (brake drag, etc.)
 Refer to UTILITY [12/2021 - ]
Suspension, tires, etc. Television camera assembly optical axis (Back camera position setting) Parking Assist Monitor System Refer to CALIBRATION [10/2022 - ]
Parking assist ECU initialization Panoramic View Monitor System (for HV model) Refer to CALIBRATION [10/2022 - ]
NOTE:

For the hybrid transaxle fluid, use Toyota Genuine ATF WS.

Using transmission fluid other than the above type may cause abnormal noise or vibration, or ultimately damage the transmission of your vehicle.

scientia non olet · About LEMON Manuals