Caution / Notice / Hint

WARNING: This page is about a different variant/trim than selected.

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear drive shaft oil seal LH or rear drive shaft oil seal RH removal/installation are shown below.

NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Rear wheel alignment adjustment	Clear zero point calibration data and stored linear solenoid valve calibration data Initialization and calibration of the linear solenoid valve Yaw rate and acceleration sensor zero point calibration	VSC malfunction	Refer to UTILITY [02/2019 - 12/2021]
Suspension, tires, etc.	Television camera assembly optical axis (Back camera position setting)	Parking Assist Monitor System	Refer to CALIBRATION [11/2018 - 10/2022]
Suspension, tires, etc.	Parking assist ECU initialization Adjust steering angle	Panoramic View Monitor System (for HV model)	Refer to CALIBRATION [11/2018 - 10/2022]

NOTE:

For the hybrid transaxle fluid, use Toyota Genuine ATF WS.

Using transmission fluid other than the above type may cause abnormal noise or vibration, or ultimately damage the transmission of your vehicle.