DTC U0293-87: Lost Communication with Hybrid/EV Powertrain Control Module Missing Message [06/2020 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK DTC OUTPUT (HV BATTERY)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Enter the following menus: Powertrain / HV Battery / Trouble Codes.
- Check for DTCs.
Powertrain > HV Battery > Trouble Codes
- Turn the ignition switch off.
Result
Proceed to NEXT
Result:
NEXT
GO TO CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [02/2019 - ]