LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 LE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 142 (Engine Mechanical System (A25A-FXS) - Service Information (2 Of 6)) >> Front Crankshaft Oil Seal >> Removal [08/2020 - 12/2021] >> Procedure

Removal [08/2020 - 12/2021]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE 

    Refer to REMOVAL [08/2020 - 12/2021]

  2. REMOVE CRANKSHAFT PULLEY ASSEMBLY 

    Refer to PROCEDURE - Step 20

  3. REMOVE TIMING CHAIN COVER OIL SEAL 
    1. Using a screwdriver, pry out the timing chain cover oil seal.
      GTY855384Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      NOTE:

      After removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.

      HINT: 

      Tape the screwdriver tip before use.

scientia non olet · About LEMON Manuals