Utility [06/2020 - ]

HINT: 

• With "All Readiness", you can check whether or not the DTC judgment has been completed by using the Techstream.
• You should check "All Readiness" after simulating malfunction symptoms or for validation after finishing repairs.

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs even if no DTCs are stored.

   Powertrain > Hybrid Control > Clear DTCs 

5. Turn the ignition switch off and wait for 2 minutes or more.
6. Turn the ignition switch to ON.
7. Perform the DTC judgment driving pattern to run the DTC judgment.
8. Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.

   Powertrain > Hybrid Control > Utility 

   Tester Display
   All Readiness

9. Input the DTC to be confirmed.
10. Check the DTC judgment result.

    Techstream Display	Description
    NORMAL	DTC judgment completed System normal
    ABNORMAL	DTC judgment completed System abnormal
    INCOMPLETE	DTC judgment not completed Perform the driving pattern

    If the judgment result shows INCOMPLETE, perform the DTC confirmation driving pattern again.

11. Turn the ignition switch off.

1. Check for diagnosis related information.
   1. Connect the Techstream to the DLC3.
   2. Turn the ignition switch to ON.
   3. Turn the Techstream on.
   4. Enter the following menus: Powertrain / Hybrid Control / Utility / Diagnosis Related Information.

      Powertrain > Hybrid Control > Utility 

      Tester Display
      Diagnosis Related Information

   5. Check the Diagnosis Related Information, and then write them down.
2. Clear diagnosis related information.
   NOTE:

   Clearing the DTCs will also clear the diagnosis related information.

   1. Connect the Techstream to the DLC3.
   2. Turn the ignition switch to ON.
   3. Turn the Techstream on.
   4. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.
   5. Clear the diagnosis related information and freeze frame data.
   6. Turn the ignition switch off.