Confirmation Driving Pattern

HINT: 

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Refer to UTILITY [11/2018 - 08/2020]

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG) and turn the Techstream on.
3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
4. Turn the power switch off and wait for 2 minutes or more.
5. Turn the power switch on (IG) and turn the Techstream on.
6. With power switch on (IG) and wait for 5 seconds or more.
7. Turn the power switch on (READY) and wait for 5 seconds or more.
8. Depress the accelerator pedal of the vehicle with the engine stopped and the shift lever in P to start the engine.
   NOTE:

   As the state of charge of the HV battery may be low after driving in fail-safe mode, it will automatically be charged for 5 to 10 minutes with power switch on (READY) after repairs have been performed.

   HINT: 

   Check that there are no abnormalities (abnormal sounds, coolant leaks, etc.).

9. Enter the following menus: Powertrain / Motor Generator / Utility / All Readiness.
10. Check the DTC judgment result.

    HINT: 

    • If the judgment result shows NORMAL, the system is normal.
    • If the judgment result shows ABNORMAL, the system has a malfunction.
    • If the judgment result shows INCOMPLETE, perform driving pattern again.