Precaution [08/2020 - 12/2021]
WARNING: This page is about a different car, the 2025 Toyota RAV4, 2024 Toyota RAV4, 2023 Toyota RAV4, 2022 Toyota RAV4, and 2021 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- WHEN USING TECHSTREAM WARNING:
- Strictly obey all traffic rules and regulations.
- Do not drive the vehicle with the Techstream cable contacting the pedals, shift lever or steering wheel.
- Driving the wheel with the Techstream cable contacting these areas could impede vehicle control, resulting in a serious accident.
- Do not operate the Techstream while driving the vehicle.
- Operating the Techstream while driving the vehicle will prevent you from paying sufficient attention to vehicle surroundings, and could result in a serious accident.
- INITIALIZATION NOTE:
- Before replacing the ECM, refer to Registration.
- w/ Smart Key System:
Refer to REGISTRATION [08/2020 - 12/2021]
- w/o Smart Key System:
Refer to REGISTRATION [11/2018 - 10/2022]
- w/ Smart Key System:
- Perform Learning Value Reset and Idle Learning after replacing or servicing parts related to engine operation.
Refer to INITIALIZATION [08/2020 - 12/2021]
- Make sure to perform Reset Memory (A/T initialization), when replacing the automatic transaxle assembly, ECM or engine assembly.
- for 2WD:
Refer to INITIALIZATION [11/2018 - ]
- for AWD:
Refer to INITIALIZATION [11/2018 - ]
- for 2WD:
- Perform "Grille Shutter Control Mode Switching and Grille Shutter Initialization" after replacing the swing grille actuator assembly or radiator shutter sub-assembly.
Refer to INITIALIZATION [11/2018 - 12/2021]
- When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.
Refer to INITIALIZATION [08/2020 - 12/2021]
- Before replacing the ECM, refer to Registration.