Installation [11/2018 - ]: Procedure

INSTALL OIL COOLER ASSEMBLY
1. Install a new oil control valve filter to the cylinder block sub-assembly.
2. Install 2 new oil cooler gaskets to the oil cooler assembly.
3. Install the oil cooler assembly to the cylinder block sub-assembly with the 4 bolts.
  Torque: 16 N.m (163 kgf/cm, 12 ft.lbf)
4. Connect the No. 1 water by-pass hose and No. 2 water by-pass hose to the oil cooler assembly, and slide the 2 clips to secure them.
ADD ENGINE OIL
Refer to PROCEDURE - Step 5 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 5 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 5 [12/2021 - 10/2023] , or refer to PROCEDURE - Step 5 [10/2023 - ]
ADD ENGINE COOLANT
Refer to PROCEDURE - Step 2
INSPECT FOR COOLANT LEAK
Refer to PROCEDURE - Step 1
CHECK ENGINE OIL LEVEL
Refer to PROCEDURE - Step 1 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 1 [08/2020 - 10/2023] , or refer to PROCEDURE - Step 1 [10/2023 - ]
INSPECT ENGINE OIL LEAK
Refer to PROCEDURE - Step 6 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 6 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 6 [12/2021 - 10/2023] , or refer to PROCEDURE - Step 6 [10/2023 - ]
INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 99 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 99 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 99 [12/2021 - ]
INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 100 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 100 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 100 [12/2021 - ]
INSTALL FRONT FENDER FRONT SPLASH SHIELD RH
Refer to PROCEDURE - Step 102 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 102 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 102 [12/2021 - ]
INSTALL FRONT FENDER FRONT SPLASH SHIELD LH
Refer to PROCEDURE - Step 101 [11/2018 - 08/2020] , or refer to PROCEDURE - Step 101 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 101 [12/2021 - ]