Removal [08/2020 - 12/2021]: Procedure

PRECAUTION

WARNING:

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Be sure to read precaution thoroughly before servicing.

Refer to PRECAUTION [08/2020 - ]

NOTE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Refer to PRECAUTION [11/2018 - ]

DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Disconnect the cable from the negative (-) auxiliary battery terminal.

Refer to PROCEDURE - Step 2

WARNING:

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.

NOTE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [08/2020 - 12/2021]

REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT ASSEMBLY
Refer to REMOVAL [08/2020 - 12/2021]

REMOVE TRANSPONDER KEY ECU (IMMOBILISER CODE ECU)

NOTE:

Do not reuse dropped or damaged parts.

	Remove in this Direction (1)
	Remove in this Direction (2)

Detach the claw in the direction (1) indicated by the arrow shown in the illustration.

Detach the guide in the direction (2) indicated by the arrow shown in the illustration and remove the transponder key ECU (immobiliser code ECU).