Removal [10/2019 - 08/2020]: Procedure
- PRECAUTION WARNING:
Be sure to read precaution thoroughly before servicing.
- w/ Occupant Classification System:
Refer to PRECAUTION [02/2019 - 08/2020]
- w/o Occupant Classification System:
Refer to PRECAUTION [11/2018 - 08/2020]
NOTE:After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Refer to PRECAUTION [11/2018 - ]
- w/ Occupant Classification System:
- REMOVE DECK BOARD ASSEMBLY (for HV Model)
Refer to PROCEDURE - Step 2
- REMOVE REAR NO. 2 FLOOR BOARD (for HV Model)
Refer to PROCEDURE - Step 3
- REMOVE BATTERY HOLE COVER (for HV Model)
Refer to PROCEDURE - Step 4
- DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
- Disconnect the cable from the negative (-) auxiliary battery terminal.
- for A25A-FKS:
Refer to PROCEDURE - Step 2
- for A25A-FXS:
Refer to PROCEDURE - Step 5
WARNING:- Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
- If the airbag deploys for any reason, it may cause a serious accident.
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [10/2019 - 06/2020] , or refer to INITIALIZATION [06/2020 - 08/2020]
- for A25A-FKS:
- Disconnect the cable from the negative (-) auxiliary battery terminal.
- REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT ASSEMBLY
for A25A-FXS:
Refer to REMOVAL [10/2019 - 08/2020]
for A25A-FKS:
Refer to REMOVAL [10/2019 - 08/2020]
- REMOVE ID CODE BOX (IMMOBILISER CODE ECU) NOTE:
Do not reuse dropped or damaged parts.