Installation [11/2018 - 08/2020]: Procedure
- INSTALL ID CODE BOX (IMMOBILISER CODE ECU) NOTE:
Do not reuse dropped or damaged parts.
Install in this Direction (1) Install in this Direction (2) Attach in the direction indicated by the arrow (1) shown in the illustration to attach the guide.
- Attach in the direction indicated by the arrow (2) shown in the illustration to attach the claw to install the ID code box (immobiliser code ECU).
- INSTALL INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONING UNIT ASSEMBLY
for A25A-FXS:
Refer to INSTALLATION [11/2018 - 02/2019] , or refer to INSTALLATION [02/2019 - 08/2020]
for A25A-FKS:
Refer to INSTALLATION [11/2018 - 08/2020]
- CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
- for A25A-FKS:
Refer to PROCEDURE - Step 2
- for A25A-FXS:
Refer to PROCEDURE - Step 2
NOTE:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [11/2018 - 02/2019] , or refer to INITIALIZATION [02/2019 - 10/2019] , or refer to INITIALIZATION [10/2019 - 06/2020] , or refer to INITIALIZATION [06/2020 - 08/2020]
- for A25A-FKS:
- INSTALL BATTERY HOLE COVER (for HV Model)
Refer to PROCEDURE - Step 3
- INSTALL REAR NO. 2 FLOOR BOARD (for HV Model)
Refer to PROCEDURE - Step 4
- INSTALL DECK BOARD ASSEMBLY (for HV Model)
Refer to PROCEDURE - Step 5
- CHECK SRS WARNING LIGHT
- w/ Occupant Classification System:
Refer to OPERATION CHECK [11/2018 - 02/2019] , or refer to OPERATION CHECK [02/2019 - 08/2020]
- w/o Occupant Classification System:
Refer to OPERATION CHECK [11/2018 - 08/2020]
- w/ Occupant Classification System:
- PERFORM DIAGNOSTIC SYSTEM CHECK
- w/ Occupant Classification System:
- w/o Occupant Classification System:
- PERFORM CODE REGISTRATION
- for HV Model:
Refer to REGISTRATION [11/2018 - 10/2019] , or refer to REGISTRATION [10/2019 - 12/2021]
- for Gasoline Model:
Refer to REGISTRATION [11/2018 - 10/2019] , or refer to REGISTRATION [10/2019 - 08/2020]
- for HV Model: