DTC U11D0-87: Lost Local Communication with MET Missing Message [10/2022 - ]: Procedure
- CHECK FOR CAN BUS WIRE (COMBINATION METER ASSEMBLY MAIN WIRE)
Pre-procedure1
- Disconnect the cable from the negative (-) auxiliary battery terminal.
- Disconnect the G18*1 or G140*2 combination meter assembly connector.
- *1: except 12.3 Inch TFT Display Type
- *2: for 12.3 Inch TFT Display Type
Procedure1
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition G18-27 (MSCH) - G18-10 (MSCL)*1 Cable disconnected from negative (-) auxiliary battery terminal 108 to 132 Ω G140-32 (MSCH) - G140-15 (MSCL)*2 Cable disconnected from negative (-) auxiliary battery terminal 108 to 132 Ω *1: except 12.3 Inch TFT Display Type
*2: for 12.3 Inch TFT Display Type
Result
Proceed to OK NG Post-procedure1
- None
Result:
OK
REPLACE COMBINATION METER ASSEMBLY. Refer to REMOVAL [10/2022 - ]
Result:
NG
See step 2
- CHECK FOR CAN BUS WIRE (RADIO AND DISPLAY RECEIVER ASSEMBLY MAIN WIRE)
Pre-procedure1
- Disconnect the cable from the negative (-) auxiliary battery terminal.
- Disconnect the G138 radio and display receiver assembly connector.
Procedure1
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition G138-11 (CNH1) - G138-12 (CNL1) Cable disconnected from negative (-) auxiliary battery terminal 108 to 132 Ω Result
Proceed to OK NG Post-procedure1
- None
Result:
OK
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY. Refer to REMOVAL [10/2022 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR