Removal [11/2018 - ]: Procedure

Refer to PROCEDURE - Step 17 [11/2018 - 02/2019] , or refer to PROCEDURE - Step 17 [02/2019 - 10/2019] , or refer to PROCEDURE - Step 17 [10/2019 - 08/2020] , or refer to PROCEDURE - Step 18 [08/2020 - 12/2021] , or refer to PROCEDURE - Step 18 [12/2021 - 10/2022] , or refer to PROCEDURE - Step 18 [10/2022 - ]

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Turn in this Direction

   Disconnect the connector.

2. Turn the stop light switch assembly counterclockwise and remove it.

1. Using a screwdriver, detach the claw and remove the stop light switch mounting adjuster.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Protective Tape

   NOTE:

   The stop light switch mounting adjuster must not be reused.

   HINT: 

   Tape the screwdriver tip before use.