LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> RAV4 LE, AWD >> Labor Times >> Other Variant >> Brakes >> Mechanical - Hydraulic >> Brake Shoes &/Or Pads >> Remove & Replace

Brake Shoes &/Or Pads: Remove & Replace

WARNING: This page is about the RAV4 Adventure, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.

Applies ToNoteStandard HoursWarranty HoursSkill Level
Gas, All1.8B
Gas, Front or Rear,Both Sides1.0B
Combination Procedure: BRAKE HOSE: Replace:
Gas, Each Additional0.2B
Gas, OneIncludes: Bleed Brakes.0.3B
Combination Procedure: CALIPER: Overhaul:
Gas, OneIncludes: Bleed Brakes.0.5B
Combination Procedure: CALIPER: Replace:
Gas, OneIncludes: Bleed Brakes.0.3B
Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle:
0.5B
Combination Procedure: DISC ROTOR: Correct:
Lateral Runout,EachCorrect Rotor lateral runout by indexing.0.2B
Combination Procedure: DISC ROTOR: Replace:
Each0.1B
Combination Procedure: ELECTRONIC PARKING BRAKE SYSTEM: Disable & Enable:
Brake Pad Replacement ModeIncludes: Disable and enable electronic brake system with use of scan tool or interactive vehicle controls.0.2B
Combination Procedure: HUB & ROTOR DISC: Clean & Inspect:
Corrosion,EachClean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor.0.2B