LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Prius XLE >> Repair and Diagnosis >> External Pages >> Different car >> Section 342 (Starting System (Service Information) [2GR-FKS]) >> Starter >> Removal [04/2018 - 08/2021] >> Procedure

Removal [04/2018 - 08/2021]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Avalon, 2021 Toyota Avalon, 2020 Toyota Avalon, and 2019 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION 
    NOTE:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Refer to PRECAUTION [04/2018 -]

  2. REMOVE BATTERY 

    Refer to REMOVAL [04/2018 - 08/2021]

  3. REMOVE COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 1

  4. REMOVE V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 19

  5. REMOVE INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 20

  6. REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 21

  7. REMOVE ECM 

    Refer to PROCEDURE - Step 5

  8. REMOVE BATTERY CLAMP SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 25

  9. REMOVE STARTER ASSEMBLY 
    1. Disconnect the starter assembly connector.
      GTY768404Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Open the terminal cap.
    3. Remove the nut and disconnect the engine wire from the terminal 30.
    4. Remove the 2 bolts and starter assembly.
      GTY768403Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals