LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Prius XLE >> Repair and Diagnosis >> External Pages >> Different car >> Section 335 (Electric Parking System - Diagnostic Codes & Symptom Tests (Except Hybrid)) >> ELECTRIC PARKING BRAKE SYSTEM (for Gasoline Model) >> DTC C0610-12: Right Electric Parking Brake Actuator Control Circuit Short to Battery [08/2021 -] >> Procedure

DTC C0610-12: Right Electric Parking Brake Actuator Control Circuit Short to Battery [08/2021 -]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Avalon, 2021 Toyota Avalon, 2020 Toyota Avalon, and 2019 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR SHORT TO +B 
    1. Turn the engine switch off.
    2. Make sure the No. 1 parking brake wire assembly is securely installed.
    3. Disconnect the Y4 parking brake actuator assembly RH connector.
    4. Measure the voltage according to the value(s) in the table below.
      GTY1026487Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of No. 1 Parking Brake Wire Assembly
      (to Parking Brake Actuator Assembly RH)

      Standard Voltage

      Tester Connection Condition Specified Condition
      Y4-2 (RE+) - Y4-1 (RE-) Electric parking brake not operating Below 1 V

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE PARKING BRAKE ACTUATOR ASSEMBLY RH. Refer to  REMOVAL [04/2018 -] 

    Result: 

    NG 

    See step  2

  2. CHECK FOR SHORT TO +B 
    1. Disconnect the YK1 No. 1 parking brake wire assembly connector.
    2. Measure the voltage according to the value(s) in the table below.
      GTY1026733Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector
      (to No. 1 Parking Brake Wire Assembly)

      Standard Voltage

      Tester Connection Condition Specified Condition
      YK1-2 - YK1-1 Electric parking brake not operating Below 1 V

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE NO. 1 PARKING BRAKE WIRE ASSEMBLY 

    Result: 

    NG 

    See step  3

  3. CHECK FOR SHORT TO +B 
    1. Disconnect the YK1 No. 1 parking brake wire assembly connector.
    2. Disconnect the A28 skid control ECU (brake actuator assembly) connector.
    3. Measure the voltage according to the value(s) in the table below.
      GTY1026564Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector *b (to Skid Control ECU (Brake Actuator Assembly))
      *c (to No. 1 Parking Brake Wire Assembly) - -

      Standard Voltage

      Tester Connection Condition Specified Condition
      YK1-2 or A28-2 (MRR+) - Body ground Always Below 1 V
      YK1-1 or A28-3 (MRR-) - Body ground Always Below 1 V

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY). Refer to  REMOVAL [08/2021 -] 

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

scientia non olet · About LEMON Manuals