Installation [08/2020 -]: Procedure
WARNING: This page is about a different car, the 2022 Toyota Avalon, 2021 Toyota Avalon, 2020 Toyota Avalon, and 2019 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL NO. 1 SWITCH WIRE (w/ Shift Paddle Switch)
for Gasoline Model: Refer to PROCEDURE - Step 1
for HV Model: Refer to PROCEDURE - Step 1
- INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/ Shift Paddle Switch)
for Gasoline Model: Refer to PROCEDURE - Step 2
for HV Model: Refer to PROCEDURE - Step 2
- INSTALL STEERING PAD SWITCH ASSEMBLY
See step 1
- ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
- INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Refer to PROCEDURE - Step 9
- INSTALL STEERING WHEEL ASSEMBLY
- Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.
*a Matchmark - Using a 10 mm hexagon socket wrench, install the steering wheel assembly set bolt.
Torque: 62 N*m (632 kgf*cm, 46 ft.*lbf)
- Connect each connector to the spiral cable with sensor sub-assembly and steering wheel assembly.
- Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.
- CHECK STEERING WHEEL CENTER POINT
- INSTALL HORN BUTTON ASSEMBLY
Refer to INSTALLATION [08/2020 -]