LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Prius Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 299 (Electric Parking System - Diagnostic Codes & Symptom Tests (Hybrid)) >> ELECTRIC PARKING BRAKE SYSTEM (for HV Model) >> DTC C060B-12: Left Electric Parking Brake Actuator Control Circuit Short to Battery [08/2021 -] >> Procedure

DTC C060B-12: Left Electric Parking Brake Actuator Control Circuit Short to Battery [08/2021 -]: Procedure

WARNING: This page is about a different car, the 2022 Toyota Avalon, 2021 Toyota Avalon, 2020 Toyota Avalon, and 2019 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FOR SHORT TO +B 
    1. Turn the power switch off.
    2. Make sure the No. 2 parking brake wire assembly is securely installed.
    3. Disconnect the Y1 parking brake actuator assembly LH connector.
    4. Measure the voltage according to the value(s) in the table below.
      GTY1027019Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of No. 2 Parking Brake Wire Assembly
      (to Parking Brake Actuator Assembly LH)

      Standard Voltage

      Tester Connection Condition Specified Condition
      Y1-2 (LE+) - Y1-1 (LE-) Electric parking brake not operating Below 1 V

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE PARKING BRAKE ACTUATOR ASSEMBLY LH. Refer to  REMOVAL [04/2018 -] 

    Result: 

    NG 

    See step  2

  2. CHECK FOR SHORT TO +B 
    1. Disconnect the YK2 No. 2 parking brake wire assembly connector.
    2. Measure the voltage according to the value(s) in the table below.
      GTY1026819Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector
      (to No. 2 Parking Brake Wire Assembly)

      Standard Voltage

      Tester Connection Condition Specified Condition
      YK2-2 - YK2-1 Electric parking brake not operating Below 1 V

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE NO. 2 PARKING BRAKE WIRE ASSEMBLY 

    Result: 

    NG 

    See step  3

  3. CHECK FOR SHORT TO +B 
    1. Disconnect the YK2 No. 2 parking brake wire assembly connector.
    2. Disconnect the A39 parking brake ECU (brake actuator assembly) connector.
    3. Measure the voltage according to the value(s) in the table below.
      GTY1026453Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector *b (to Parking Brake ECU (Brake Actuator Assembly))
      *c (to No. 2 Parking Brake Wire Assembly) - -

      Standard Voltage

      Tester Connection Condition Specified Condition
      YK2-2 or A39-7 (MRL+) - Body ground Always Below 1 V
      YK2-1 or A39-8 (MRL-) - Body ground Always Below 1 V

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    REPLACE PARKING BRAKE ECU (BRAKE ACTUATOR ASSEMBLY). Refer to  REMOVAL [08/2021 -] 

    Result: 

    NG 

    REPAIR OR REPLACE HARNESS OR CONNECTOR 

scientia non olet · About LEMON Manuals