LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Prius Limited >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control System - Service Information >> Brake Pedal Stroke Sensor >> Removal [07/2020 - ] >> Procedure

Removal [07/2020 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Refer to PRECAUTION [08/2019 - ]

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to PROCEDURE - Step 2

  3. REMOVE FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 19

  4. REMOVE COWL SIDE TRIM BOARD LH 

    Refer to PROCEDURE - Step 20

  5. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 9

  6. REMOVE INSTRUMENT PANEL FINISH PANEL END LH 

    Refer to PROCEDURE - Step 5

  7. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY 

    Refer to PROCEDURE - Step 6

  8. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 10

  9. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY 

    Refer to PROCEDURE - Step 11

  10. REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY 
    1. Disconnect the connector from the brake pedal stroke sensor assembly.
      GTY557803Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 nuts and brake pedal stroke sensor assembly from the brake pedal support assembly.
      NOTE:
      • Do not drop the brake pedal stroke sensor assembly.
      • If the brake pedal stroke sensor assembly has been dropped, replace the brake pedal stroke sensor assembly with a new one.
scientia non olet · About LEMON Manuals