Inspection [11/2015 - ]: Procedure
- INSPECT BRAKE BOOSTER PUMP ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Brake Booster Pump Assembly)Standard Resistance
Click Location & Routing(A12)
Click Connector(A12)
Tester Connection Condition Specified Condition A12-2 (BM1) - A12-4 (GND1) Always 10 Ω or less A12-1 (BM2) - A12-3 (GND2) Always 10 Ω or less A12-2 (BM1) - A12-1 (BM2) Always Below 1 Ω A12-4 (GND1) - A12-3 (GND2) Always Below 1 Ω
- Measure the resistance according to the value(s) in the table below.