LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Prius LE AWD-e >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display - Service Information >> Combination Meter >> Installation [11/2015 -] >> Procedure

Installation [11/2015 -]: Procedure

  1. INSTALL COMBINATION METER ASSEMBLY 
    1. Connect the 2 connectors.
    2. Engage the clamp.
    3. Install the combination meter assembly with the 4 screws.
  2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY 
    1. Engage the 10 guides and 17 clips to install the instrument cluster finish panel assembly as shown in the illustration.
      GTY609335Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Install in this Direction - -
    2. Engage the 4 guides and 11 clips to install the upper instrument panel assembly as shown in the illustration.
      GTY582011Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Install in this Direction - -
      NOTE:
      • Do not damage the upper instrument panel assembly.
      • Do not allow the wire harnesses to interfere with the surrounding parts.
    3. Install the 2 clips.
  3. INSTALL NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 5

  4. INSTALL FRONT PILLAR GARNISH RH 

    HINT: 

    Use the same procedure as for the LH side.

    Refer to PROCEDURE - Step 48 [11/2015 - 12/2018] , or refer to PROCEDURE - Step 44 [12/2018 - 07/2020] , or refer to PROCEDURE - Step 44 [07/2020 -]

  5. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP RH 

    Refer to PROCEDURE - Step 59 [11/2015 - 12/2018] , or refer to PROCEDURE - Step 55 [12/2018 - 07/2020] , or refer to PROCEDURE - Step 55 [07/2020 -]

  6. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 9

  7. INSTALL FRONT PILLAR GARNISH LH 

    Refer to PROCEDURE - Step 48 [11/2015 - 12/2018] , or refer to PROCEDURE - Step 44 [12/2018 - 07/2020] , or refer to PROCEDURE - Step 44 [07/2020 -]

  8. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH 

    Refer to PROCEDURE - Step 49 [11/2015 - 12/2018] , or refer to PROCEDURE - Step 45 [12/2018 - 07/2020] , or refer to PROCEDURE - Step 45 [07/2020 -]

  9. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [11/2015 - 11/2017] , or refer to INITIALIZATION [11/2017 - 12/2018] , or refer to INITIALIZATION [12/2018 - 08/2019] , or refer to INITIALIZATION [08/2019 - 07/2020] , or refer to INITIALIZATION [07/2020 -]