Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front door belt moulding assembly removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replacement Part or Procedure	Necessary Procedure	Effects/Inoperative when not Performed	Link
Front door glass Front door grass run	Initialize power window control system	Auto up and down function Jam protection function Remote control function Key-linked function Wireless transmitter-linked function Catch protection function Window open warning function	Refer to INITIALIZATION [06/2015 - ]

HINT:

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.