Status Signal Circuit [06/2015 - ]: Procedure

1. Measure the voltage according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Component with harness connected (Mobile Wireless Charger Cradle Assembly)

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   e1-7 (L) - Body ground	Within 5 seconds after turning power switch from off to on (ACC)*1	4.5 to 6.0 V
   	When charging	Below 1 V
   	When charging is temporarily stopped by charging stop signal from certification ECU (smart key ECU assembly)*2	4.5 to 6.0 V

   *1: When the power switch is turned from off to on (ACC), the mobile wireless charger cradle assembly checks the charging stop signal for 5 seconds. If the charging stop signal is not 4 V or higher for 0.8 seconds or more within 5 seconds continuously, the mobile wireless charger cradle assembly determines that there is an open circuit in the charging stop signal circuit, blinks the indicator amber (pattern 1), and stops operation until the next time the power switch is turned on (ACC). For the indicator blinking patterns.

   *2: For the certification ECU (smart key ECU assembly) charging stop signal reception conditions.

   HINT: 

   Check with the certification ECU (smart key ECU assembly) connector connected.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [06/2015 - ]  

Result: 

NG 

See step  2

1. Disconnect the e1 mobile wireless charger cradle assembly connector.
2. Disconnect the G39 certification ECU (smart key ECU assembly) connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   e1-7 (L) - G39-21 (ASEL)	Always	Below 1 Ω
   e1-7 (L) or G39-21 (ASEL) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR