Operation Check [11/2018 - ]
- INSPECT INDICATOR/WARNING LIGHT
- Check the following indicators and warning lights.
Indicator/Warning Light Switch Condition Specified Condition EPS warning light Power switch off → on (IG) - Illuminates when power switch turned on (IG)
- Turns off when engine started
Brake warning light Power switch off → on (IG) Comes on for 3 seconds Charge warning light Master warning light ABS warning light Slip indicator light Hydrogen system warning light PCS OFF warning light Automatic high beam indicator light FC coolant temperature warning light VSC OFF indicator light ECB warning light Tire pressure warning light SRS warning light Power switch off → on (IG) Comes on for 6 seconds
- Check the following indicators and warning lights.
- INSPECT SPEEDOMETER
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / ABS/VSC/TRAC / Data List.
Chassis > ABS/VSC/TRAC > Data List
Tester Display Measurement Item Normal Condition Reference Value Diagnostic Note Vehicle Speed Vehicle speed Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost same as actual vehicle speed - Chassis > ABS/VSC/TRAC > Data List
Tester Display Vehicle Speed WITH KM/H UNITSStandard Indication (km/h) Acceptable Range (km/h) 20 20.0 to 22.0 40 41.0 to 43.0 60 62.0 to 64.0 80 83.0 to 85.0 100 104.0 to 106.0 120 124.0 to 126.0 140 145.0 to 147.0 160 166.0 to 168.0 WITH MPH UNITSStandard Indication (mph) Acceptable Range (mph) 20 20.0 to 22.0 40 41.0 to 43.0 60 62.0 to 64.0 80 83.0 to 85.0 100 104.0 to 106.0 120 124.0 to 126.0 140 145.0 to 147.0 160 166.0 to 168.0 If the result is not as specified, the speedometer may have a malfunction.
NOTE:Do not use worn, underinflated or overinflated tires as the speedometer reading will be inaccurate.