Removal [06/2015 - ]: Procedure

REMOVE FRONT FENDER TOP REINFORCEMENT SUB-ASSEMBLY

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a clip remover, disengage the clip A.

Using a moulding remover B, disengage the clips in the order shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

	Remove in this Direction (1)
	Remove in this Direction (2)

Disengage the guides to remove the front fender top reinforcement sub-assembly as shown in the illustration.

REMOVE FRONT PILLAR UPPER COVER SUB-ASSEMBLY

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Protective Tape

Apply protective tape around the front pillar upper cover sub-assembly.

Remove the 4 screws.

Disengage the clips to remove the front pillar upper cover sub-assembly as shown in the illustration.

	Place Hands Here
	Remove in this Direction

NOTE:

Disengage the clips from the front to the rear of the vehicle. When the clips cannot be disengaged from the vehicle in the ordinary process, push them out from the inside of the vehicle.