Disposal [06/2015 - ]: Procedure

DISPOSE OF HOOD SUPPORT ASSEMBLY

NOTE:

Make sure the piston rods are in the fully extended stake before performing work.

Secure the hood support assembly horizontally in a vise with the piston rod pulled out.

Wearing safety glasses, gradually cut a part between A and B shown in the illustration to discharge the gas inside.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Area	Measurement
A - B	150 mm (5.906 in.)

WARNING:

Always use proper safety equipment and be careful when drilling because shards of metal may fly about.

HINT:

The gas is colorless, odorless and non-poisonous.