LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Mirai >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> (Doors / Hatch) - Service Information >> Fuel Lid Opener Switch >> Inspection [06/2015 - ] >> Procedure

Inspection [06/2015 - ]: Procedure

  1. INSPECT LUGGAGE COMPARTMENT DOOR OPENING SWITCH ASSEMBLY 
    1. Check the operation of the luggage compartment door opening switch assembly.
      GTY552927Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Luggage Door Opening Switch Assembly)
      *b Fuel Lid Open Switch
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Switch Condition Specified Condition
        2 (B) - 3 (L) Switch not pressed 10 kΩ or higher
        Switch pressed Below 1 Ω
    2. Inspect the illumination.
      1. Apply auxiliary battery voltage to the luggage compartment door opening switch assembly connector, and check that the luggage compartment door opening switch assembly LED illuminates.

        OK

        Measurement Condition Specified Condition
        Auxiliary battery positive (+) - Terminal 1 (ILL+)
        Auxiliary battery negative (-) - Terminal 5 (ILL-)        		 LED illuminates
        1. If the result is not as specified, replace the luggage compartment door opening switch assembly.
scientia non olet · About LEMON Manuals