Unable To Connect To Call Center [06/2015 - 01/2018]: Procedure

1. Move the vehicle.
   1. If the vehicle is outside the communication service area, move the vehicle to a communication service area, wait for a while and perform the operation again.

      OK

      Same problem does not occur.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END 

Result: 

NG 

See step  2

1. Turn the power switch off.
2. Connect the Techstream to the DLC3.
3. Turn the power switch on (IG) and wait for 10 seconds.
4. Turn the Techstream on.
5. Perform "Health Check" and check for current DTCs.

   Refer to HEALTH CHECK [06/2015 - 01/2018]

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [06/2015 - 01/2018] 

Result: 

A 

See step  3

1. Check for PRL update.

   Refer to PRL UPDATE [06/2015 - 01/2018]

2. Check if the same problem occurs again.

   OK

   Same problem does not occur.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END 

Result: 

NG 

See step  4

1. Check "DCM Operation History".

   Refer to DCM OPERATION HISTORY [06/2015 - ]

   Result

   Result	Proceed to
   Signal strength is weak (0 or 1)	A
   Communication indicates "Fail"
   No problems with signal strength or communication	B

   HINT: 

   If there was a communication problem in the past but the communications are working correctly now, it is possible that the source of the problem was temporary radio interference, or the vehicle may have been outside the service area.

Result: 

B 

END 

Result: 

A 

See step  5

1. Replace the DCM (Telematics Transceiver).

   Refer to REMOVAL [06/2015 - 01/2018]

   NOTE:

   • The power switch must be off.
   • Do not swap the DCM (Telematics Transceiver) with one from another vehicle.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  6

1. Perform "PRL UPDATE".

   Refer to PRL UPDATE [06/2015 - 01/2018]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

PERFORM DCM ACTIVATION. Refer to  DCM ACTIVATION [06/2015 - 01/2018]