DTC B2414: Steering Position Sensor Malfunction [06/2015 - ]: Procedure

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [06/2015 - 11/2018] , or refer to DTC CHECK / CLEAR [11/2018 - ]

   Body Electrical > HL AutoLeveling > Clear DTCs 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [06/2015 - 11/2018] , or refer to DTC CHECK / CLEAR [11/2018 - ]

   Body Electrical > HL AutoLeveling > Trouble Codes 

   Result

   Result	Proceed to
   DTC B2414 output does not occur	A
   DTC B2414 output occurs	B

Result: 

A 

USE SIMULATION METHOD TO CHECK. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2015 - 11/2018]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ] 

Result: 

B 

See step  3

1. Temporarily replace the steering sensor with a new or normally functioning one.

   Refer to REMOVAL [06/2015 - 11/2018] , or refer to REMOVAL [11/2018 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. Turn the power switch on (IG).
2. Inspect the light using the dimmer switch.
3. Check for DTCs.

   Refer to DTC CHECK / CLEAR [06/2015 - 11/2018] , or refer to DTC CHECK / CLEAR [11/2018 - ]

   Body Electrical > HL AutoLeveling > Trouble Codes 

   Result

   Result	Proceed to
   DTC B2414 output does not occur	A
   DTC B2414 output occurs	B

Result: 

A 

END (STEERING SENSOR WAS DEFECTIVE) 

Result: 

B 

REPLACE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY LH