Red Indicator Remains On [06/2015 - 01/2018]: Procedure

1. Turn the power switch off.
2. Connect the Techstream to the DLC3.
3. Turn the power switch on (IG) and wait for 10 seconds.
4. Turn the Techstream on.
5. Perform "Health Check" and check for current DTCs.

   Refer to HEALTH CHECK [06/2015 - 01/2018]

   Result

   Result	Proceed to
   DTCs are not output	A
   DTCs are output	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [06/2015 - 01/2018] 

Result: 

A 

See step  2

1. Replace the DCM (Telematics Transceiver).

   Refer to REMOVAL [06/2015 - 01/2018]

   NOTE:

   • The power switch must be off.
   • Do not swap the DCM (Telematics Transceiver) with one from another vehicle.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Perform "PRL UPDATE".

   Refer to PRL UPDATE [06/2015 - 01/2018]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

PERFORM DCM ACTIVATION. Refer to  DCM ACTIVATION [06/2015 - 01/2018]