Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the DCM (telematics transceiver) removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replacement Part or Procedure	Necessary Procedure	Effects/Inoperative when not Performed	Link
DCM (telematics transceiver)	Vehicle binding settings Entune communication initialization or Entune usage reactivation procedure Helpnet service start procedure	Entune service Helpnet service Hands-free car phone using the DCM (only when there is a contract for hands-free car phone) Remote service.	Refer to DCM ACTIVATION [01/2018 - ]