LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Mirai >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Monitor - Service Information >> ULTRASONIC SENSOR (for Rear Side) >> Inspection [11/2018 - ] >> Procedure

Inspection [11/2018 - ]: Procedure

  1. INSPECT REAR CENTER ULTRASONIC SENSOR 
    1. Check the resistance.
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        4 (BI) - 6 (EI) Always 10 kΩ or higher
        4 (BI) - 1 (BO) Always Below 1 Ω
        5 (SI) - 2 (SO) Always Below 30 Ω
        6 (EI) - 3 (EO) Always Below 1 Ω

        If the result is not as specified, replace the rear center ultrasonic sensor.

        GTY565900Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Rear Center Ultrasonic Sensor)
  2. INSPECT REAR CORNER ULTRASONIC SENSOR 
    1. Check the resistance.
      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection Condition Specified Condition
        4 (BI) - 6 (EI) Always 10 kΩ or higher
        4 (BI) - 1 (BO) Always Below 1 Ω
        5 (SI) - 2 (SO) Always Below 30 Ω
        6 (EI) - 3 (EO) Always Below 1 Ω

        If the result is not as specified, replace the rear corner ultrasonic sensor.

        GTY565900Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Rear Corner Ultrasonic Sensor)
scientia non olet · About LEMON Manuals