LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Mirai >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Can Communication System - Circuit Tests >> Can Communication System >> Open in One Side of CAN Branch Line [01/2018 - 11/2018] >> Caution / Notice / Hint

Caution / Notice / Hint

NOTE:
  • Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.

    Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2015 - 11/2018]

  • After performing repairs, perform the DTC check procedure and confirm that the DTCs are not output again.
  • DTC check procedure: Turn the power switch on (IG) and wait at least 2 minutes, and then drive the vehicle at a speed of 36 km/h (22 mph) or more for 300 seconds or more.
  • After the repair, perform the CAN bus check and check that all the ECUs and sensors connected to the CAN communication system are displayed.

    Refer to DIAGNOSIS SYSTEM [01/2018 - 11/2018]

HINT: 

Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.

scientia non olet · About LEMON Manuals