LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Highlander L, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 46 (Transfer Case System (GF2A) - Service Information) >> Transfer Assembly >> Removal [10/2022 - 11/2023] >> Procedure

Removal [10/2022 - 11/2023]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY 

    Refer to REMOVAL [10/2022 - 11/2023]

  2. REMOVE PROPELLER SHAFT HEAT INSULATOR 
    1. Remove the 3 bolts and propeller shaft heat insulator.
      GTY1114060Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE PROPELLER SHAFT HEAT INSULATOR BRACKET SUB-ASSEMBLY 
    1. Remove the 2 bolts and propeller shaft heat insulator bracket sub-assembly.
      GTY1118663Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE REAR ENGINE MOUNTING BRACKET SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 24

  5. REMOVE TRANSFER ASSEMBLY 
    1. Remove the 8 nuts and transfer assembly from the automatic transaxle assembly.
      GTY1110715Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals