LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Highlander L, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 46 (Transfer Case System (GF2A) - Service Information) >> Multi-Terrain Select Switch >> Removal [12/2019 - ] >> Procedure

Removal [12/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE MULTI-TERRAIN SELECT SWITCH (NO. 1 PATTERN SELECT SWITCH ASSEMBLY) (for Dial Switch Type) 

    Refer to REMOVAL [12/2019 - 10/2022] , or refer to REMOVAL [10/2022 - ]

  2. REMOVE MULTI-TERRAIN SELECT SWITCH (NO. 1 PATTERN SELECT SWITCH ASSEMBLY) (for Push Switch Type) 

    Refer to REMOVAL [12/2019 - 10/2022] , or refer to REMOVAL [10/2022 - ]

  3. REMOVE CRAWL CONTROL SWITCH ASSEMBLY (for Push Switch Type) 
    1. Disengage the 4 claws and remove the crawl control switch assembly from the switch bezel.
      GTY924103Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals