LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2020 >> Highlander L, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 46 (Transfer Case System (GF2A) - Service Information) >> Multi-Terrain Select Switch >> Installation [12/2019 - ] >> Procedure

Installation [12/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL CRAWL CONTROL SWITCH ASSEMBLY (for Push Switch Type) 
    1. Engage the 4 claws to install the crawl control switch assembly to the switch bezel.
  2. INSTALL MULTI-TERRAIN SELECT SWITCH (NO. 1 PATTERN SELECT SWITCH ASSEMBLY) (for Push Switch Type) 

    Refer to INSTALLATION [12/2019 - 10/2022] , or refer to INSTALLATION [10/2022 - ]

  3. INSTALL MULTI-TERRAIN SELECT SWITCH (NO. 1 PATTERN SELECT SWITCH ASSEMBLY) (for Dial Switch Type) 

    Refer to INSTALLATION [12/2019 - 10/2022] , or refer to INSTALLATION [10/2022 - ]

scientia non olet · About LEMON Manuals