Caution / Notice / Hint
WARNING: This page is about a different variant/trim than selected.
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during 4WD ECU assembly removal/installation are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED/INSTALLED/REPLACED
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Replacement of 4WD ECU assembly | for Dynamic Torque Control AWD System:
|
Dynamic Torque Control AWD System | Refer to CALIBRATION [12/2019 - ] |
for Dynamic Torque Vectoring AWD System:
|
Dynamic Torque Vectoring AWD System | Refer to CALIBRATION [12/2019 - ] |