Inspection [12/2019 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSPECT EGR VALVE ASSEMBLY

Measure the resistance according to the value(s) in the table below.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Component without wire harness connected (EGR Valve Assembly)

Standard Resistance

Tester Connection	Condition	Specified Condition
1 (EGA+) - 2 (EGA-)	20°C (68°F)	3.1 to 3.7 Ω
3 (EGB-) - 4 (EGB+)	20°C (68°F)	3.1 to 3.7 Ω

If the result is not as specified, replace the EGR valve assembly.