Components [12/2019 - 10/2022]
WARNING: This page is about a different variant/trim than selected.
Fig 1: Transmission Wire Replacement Components With Torque Specifications [12/2019 - 10/2022] (1 Of 4)
| Callout | Description | Callout | Description |
|---|---|---|---|
| *1 | FRONT FENDER APRON SEAL LH | - | - |
| N.m (kgf/cm, ft.lbf): Specified torque | - | - |
Fig 2: Transmission Wire Replacement Components With Torque Specifications [12/2019 - 10/2022] (2 Of 4)
| Callout | Description | Callout | Description |
|---|---|---|---|
| *1 | REFILL PLUG | *2 | NO. 1 TRANSMISSION OIL FILLER TUBE |
| *3 | OVERFLOW PLUG | *4 | GASKET |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) | • | Non-reusable part | |
| Toyota Genuine ATF WS | - | - |
Fig 3: Transmission Wire Replacement Components With Torque Specifications [12/2019 - 10/2022] (3 Of 4)
| Callout | Description | Callout | Description |
|---|---|---|---|
| *A | for AW (AISIN AW) Made | *B | for TMMWV Made |
| *1 | TRANSMISSION CASE SIDE COVER | - | - |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) | • | Non-reusable part | |
| Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent | * | Precoated part |
Fig 4: Transmission Wire Replacement Components With Torque Specifications [12/2019 - 10/2022] (4 Of 4)
| Callout | Description | Callout | Description |
|---|---|---|---|
| *1 | OIL COOLER UNION SUB-ASSEMBLY | *2 | OIL COOLER UNION BOLT |
| *3 | TRANSMISSION WIRE | *4 | TEMPERATURE SENSOR CLAMP |
| *5 | GASKET | *6 | OUTLET NO. 1 OIL COOLER HOSE |
| Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N.m (kgf/cm, ft.lbf) | • | Non-reusable part | |
| Toyota Genuine ATF WS | - | - |